I've read in various sources that it isn't advised to use hot water to sani Noryl plates in a P&F. I've also read that Noryl plates are steam sterilizable and have good heat resistance, which is completely conflicting and confusing. These P&Fs are pretty common and I'm curious if anyone is using hot water to sani. The melting point, decomp, and deformation temps for Noryl are higher than 100C, so I'm questioning the sources that state not to use hot water to sani... I'd like to use heat to sani my filtering equipment, pumps, and lines if possible.
Thanks for your feedback.
Andrew
Thanks for your feedback.
Andrew
Comment