Hello all,
I have forty plastic kegs (pka), half barrel. They have been through a few breweries, but look good. I decided to take out the spears just because they have been sitting for months, and a few of them seem to be not quite perfectly seamed on the inside. Looks like a stainless mesh with black plastic on it coming out of the side wall two thirds up on the inside. Is this the keg deteriorating from excessive washing (ha ha) or just bad manufacturing? I only took out four spears so far, but thought I should do them all for peace of mind. I will try to get a picture, but I am not sure the camera will not completely block the light. The spears are in excellent shape, and two of the four kegs I opened are fine. Assuming it IS just stainless mesh and a poor hdpe seam, with a good cleaning regimen am I fine using them?
Any advice appreciated.
Thanks,
David
I have forty plastic kegs (pka), half barrel. They have been through a few breweries, but look good. I decided to take out the spears just because they have been sitting for months, and a few of them seem to be not quite perfectly seamed on the inside. Looks like a stainless mesh with black plastic on it coming out of the side wall two thirds up on the inside. Is this the keg deteriorating from excessive washing (ha ha) or just bad manufacturing? I only took out four spears so far, but thought I should do them all for peace of mind. I will try to get a picture, but I am not sure the camera will not completely block the light. The spears are in excellent shape, and two of the four kegs I opened are fine. Assuming it IS just stainless mesh and a poor hdpe seam, with a good cleaning regimen am I fine using them?
Any advice appreciated.
Thanks,
David
Comment