Hi,
I recently installed two new pumps to replace older worn models in our brewery. Both the new and old pumps came from the same factory and are to the same spec.
The CIP pump I replaced seems to be running with a higher pressure than the older one (however this old one was also leaking and sounded terrible), but the HLT pump I put in yesterday is not providing the same pressure I had on my old model.
Could I have wired it in wrong, or do you think it is a defect with the pump itself.
I brought six new pumps total, just putting them in one at a time as our brewing schedule allows. Hoping to avoid any install errors on the rest.
Any thoughts appreciated.
Cheers,
Fraser
I recently installed two new pumps to replace older worn models in our brewery. Both the new and old pumps came from the same factory and are to the same spec.
The CIP pump I replaced seems to be running with a higher pressure than the older one (however this old one was also leaking and sounded terrible), but the HLT pump I put in yesterday is not providing the same pressure I had on my old model.
Could I have wired it in wrong, or do you think it is a defect with the pump itself.
I brought six new pumps total, just putting them in one at a time as our brewing schedule allows. Hoping to avoid any install errors on the rest.
Any thoughts appreciated.
Cheers,
Fraser
Comment