Hi.
I am trying to automate my temperature control and am using the following:
TET-612 Temperature Controller
Honeywell VR8200 A 2132 Gas Control
I was wondering if anyone had advice on wiring between the PID and the gas valve. I do not want to fry anything.
The PID has two types of outputs:
SSR activated voltage: open circuit: 8V; short circuit: 40mA.
Relay Contact volume: AC220V / 3A.
Gas Valve is controlled by 24VAC at 0.5A
I am trying to automate my temperature control and am using the following:
TET-612 Temperature Controller
Honeywell VR8200 A 2132 Gas Control
I was wondering if anyone had advice on wiring between the PID and the gas valve. I do not want to fry anything.
The PID has two types of outputs:
SSR activated voltage: open circuit: 8V; short circuit: 40mA.
Relay Contact volume: AC220V / 3A.
Gas Valve is controlled by 24VAC at 0.5A
Comment