Hi,
Wondering if anyone else out there has trouble with their flex auger snapping. Ours is only fairly short (5m) with a couple of steep bends (and a third lateral bend). It has repeatedly broken at different positions.
It is constructed from 304SS (as most are I believe?) and is fixed at the bottom (ie. it is connected to a shaft/bearing assembly under the grist case - I believe some aren't?).
We are currently looking to change the mounting on the discharge end to reduce that angle and move the grist case slightly to help with another.
Any comments...........
Cheers,
Alex
Wondering if anyone else out there has trouble with their flex auger snapping. Ours is only fairly short (5m) with a couple of steep bends (and a third lateral bend). It has repeatedly broken at different positions.
It is constructed from 304SS (as most are I believe?) and is fixed at the bottom (ie. it is connected to a shaft/bearing assembly under the grist case - I believe some aren't?).
We are currently looking to change the mounting on the discharge end to reduce that angle and move the grist case slightly to help with another.
Any comments...........
Cheers,
Alex
Comment