Building an "Octopus" keg filler

[fastricky]

Does anyone know of where I could source the parts to make an "octopus"?

Specifically the 1 1/2" TC stainless tubing with eight outlets?

[NHBrewer23]

http://jvnw.com/parts/index.php

If you go to adapters, JVNW can make a 1-1/2" spool that has 4 3/8" barbs for $175. You can just buy two of these and connect them. You'll need a cap for the end. If 3/8" isn't big enough and you wish to go with 1/2", you can always buy 3 T's and put TC to beer nut fittings. Then just use a 1/2" barb with the beer nut. Hope this helps.

[Fausto Yu-Shan]

You can make a 8 keg filler (Octopus) with a stainless steel manifold, you can find it at GW Kent for $145.00. The manifold they sell have six ends where you can assemble the keg couplers, you can add 2 Tees to make 8 fillers.


http://breweryparts.com/index.php/fi.../manifold.html

[fastricky]

You gents have done it again, thanks!

[fastricky]

Would you guys go with 3/8" barbs or 1/2"?

[Thirsty_Monk]

Would you guys go with 3/8" barbs or 1/2"?

Keg fillers are 1/2".
I would go with 1/2" barbs.

[fastricky]

Danke!....