Announcement

Collapse
No announcement yet.

Building an "Octopus" keg filler

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Building an "Octopus" keg filler

    Does anyone know of where I could source the parts to make an "octopus"?

    Specifically the 1 1/2" TC stainless tubing with eight outlets?

  • #2
    Jvnw

    JVNW (JV Northwest, Inc.) is a manufacturer of stainless steel tanks/vessels, mixers and systems. Made in USA.


    If you go to adapters, JVNW can make a 1-1/2" spool that has 4 3/8" barbs for $175. You can just buy two of these and connect them. You'll need a cap for the end. If 3/8" isn't big enough and you wish to go with 1/2", you can always buy 3 T's and put TC to beer nut fittings. Then just use a 1/2" barb with the beer nut. Hope this helps.

    Comment


    • #3
      Manifold

      You can make a 8 keg filler (Octopus) with a stainless steel manifold, you can find it at GW Kent for $145.00. The manifold they sell have six ends where you can assemble the keg couplers, you can add 2 Tees to make 8 fillers.


      Comment


      • #4
        You gents have done it again, thanks!

        Comment


        • #5
          Would you guys go with 3/8" barbs or 1/2"?

          Comment


          • #6
            Originally posted by fastricky
            Would you guys go with 3/8" barbs or 1/2"?
            Keg fillers are 1/2".
            I would go with 1/2" barbs.

            Comment


            • #7
              Danke!....

              Comment

              Working...
              X