So I've been ever so slowly fine tuning my carb setup so that I can set it and forget it. I set my head pressure to 16 and my regulator to 28. From my math 28 is correct based on tank head, wetting pressure, line loss. And altitude (I'm at 9,000ft). The only thing that I can't figure out is how to get it to carb without exceeding the PRV pressure. I get it to 20 psi in the tank and it's really close to fully carved. I then have to bleed down to 18 and then once it gets to 20 it's done.
Does anyone have any advice, thinking of lowering the head pressure to 14 and the regulator to 26 and trying that but that seems a little backwards.
Thanks
Sent from my SM-G930V using Tapatalk
Does anyone have any advice, thinking of lowering the head pressure to 14 and the regulator to 26 and trying that but that seems a little backwards.
Thanks
Sent from my SM-G930V using Tapatalk
Comment