Results 1 to 2 of 2

Thread: Turnkey brewery - Minneapolis, MN

  1. #1
    Join Date
    Feb 2012
    Location
    Minneapolis, MN
    Posts
    13

    Turnkey brewery - Minneapolis, MN

    We are selling a turnkey 5BBL brewery.

    This brewery has been good to us. So good that we are moving to a new, larger facility with all new equipment.

    Brewery Includes:
    5BBL Mash Tun
    7BBL Kettle (steam jacketed)
    Hot Liquor Tank
    250k BTU low pressure boiler (to heat the kettle)
    Two (2x) 10BBL glycol jacketed unitank fermenters with stones. Purchased new from PBST less than 2 years ago.
    One (1x) 10BBL Brite Tank with stone. Purchased new from PBST less than 2 years ago.
    Portable sanitary brewery pump,
    Thermaline T8 U20 heat exchanger
    Fully functioning cold room
    All of the fittings, hoses, etc that you will need to run the brewery.

    Additionally, our landlord has agreed to offer a lease on the location to a new brewery.
    This means that all of the improvements to the space to make it brewery ready are included.

    Improvements include:
    Trench Drain
    Floor treatment
    Venting
    Electrical, plumbing and pipefitting required (including glycol plumbing)

    Rent is also very reasonable.

    This location has already passed all federal, state, and city inspections.
    We are expecting the buyer to save months off their startup time and hundreds of man-hours due to having everything in place and ready to go, and already having been approved as a brewery.

    It is approx 800 sqft with another 550 sqft of dry storage nearby.

    We are willing to brew, clean, transfer, rack, etc. with the buyer to show them the ropes.

    We are not considering parting this out at present.

    I have more pictures and I can answer most questions via private message.

    Cheers,
    Adam
    Name:  from hotside.jpg
Views: 2119
Size:  60.8 KBName:  From garage door.jpg
Views: 2020
Size:  73.5 KBName:  Hotside.jpg
Views: 1979
Size:  57.0 KBName:  panorama.jpg
Views: 1962
Size:  79.2 KB
    Last edited by North Gate; 03-04-2014 at 08:21 PM.

  2. #2
    Join Date
    Nov 2012
    Posts
    1
    How many plates in the T8 heat exchanger?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •