Hello all,
We have a Watts b547-02agcgx33 valve filter/regulator/dryer attached to our premier stainless keg washer.
After the filter was blown down from the bottom to release a lot of moisture that had been trapped, we are having problems with the top of the valve. There is a plastic cap which has 'I' and 'X' markings and it seems to turn a screw underneath it into the valve. I can't seem to figure out what that dial does, and it is now blowing air off at full pressure. My assumption was that turning the valve all the way to the X marking would close it off entirely but that didn't work at all. Anyone have thoughts on what that is for? Is it a pressure relief valve? Or it regulates the airflow through the filter? Why after being de-pressurized will it not seal back up when I reconnect the compressor to it?
Thanks for any input
We have a Watts b547-02agcgx33 valve filter/regulator/dryer attached to our premier stainless keg washer.
After the filter was blown down from the bottom to release a lot of moisture that had been trapped, we are having problems with the top of the valve. There is a plastic cap which has 'I' and 'X' markings and it seems to turn a screw underneath it into the valve. I can't seem to figure out what that dial does, and it is now blowing air off at full pressure. My assumption was that turning the valve all the way to the X marking would close it off entirely but that didn't work at all. Anyone have thoughts on what that is for? Is it a pressure relief valve? Or it regulates the airflow through the filter? Why after being de-pressurized will it not seal back up when I reconnect the compressor to it?
Thanks for any input