We have a large 5000 water tank which we are mandated to use per city regulations.
It has been advised to me to use a 3 phase water filter consisting of the following
1) single 5 micron 20" spiral wound cartridge in "big blue" housing.
2) carbon filter for ~100 pounds of acid-washed coconut shell activated charcoal, 12x30 mesh.
3) single 1 micron 20" spiral wound cartridge in "big blue" housing.
This will be set up to run at best efficiency to fill the CLT--that is to say slow and not blasting through.
My question is, as far as matching filters to pumps / who can help me out with this. We want to design the HLT to fill reasonably fast, with 3 filtered water.
Any suggestions?
It has been advised to me to use a 3 phase water filter consisting of the following
1) single 5 micron 20" spiral wound cartridge in "big blue" housing.
2) carbon filter for ~100 pounds of acid-washed coconut shell activated charcoal, 12x30 mesh.
3) single 1 micron 20" spiral wound cartridge in "big blue" housing.
This will be set up to run at best efficiency to fill the CLT--that is to say slow and not blasting through.
My question is, as far as matching filters to pumps / who can help me out with this. We want to design the HLT to fill reasonably fast, with 3 filtered water.
Any suggestions?
Comment