I run 16 head cimec filler. Currently we use a fairly large diaphragm pump running air pressure about 42 psi. Over long runs the muffler starts to clog with ice and the pump performance decreases and comes to a halt at times. (we do have a air dryer on the compressor) I haven't been happy with the performance of the pump. Seem like something is always happening with it. Works fine with hot temps for washing or small volume filler runs but for large cold volumes it just doesn't seem to work well.
We have a fairly long run with about 12 feet of lift to the filler therefore the pump and not only co2 pushing from the brite is needed. We also find running our bowl pressures 35 to 38 psi work the best in terms of fills and fobbing.
We would like to move away from the diaphragm pump to something that will work better
Would anyone be willing to information on their setup for pushing beer to the bowl?
We have a fairly long run with about 12 feet of lift to the filler therefore the pump and not only co2 pushing from the brite is needed. We also find running our bowl pressures 35 to 38 psi work the best in terms of fills and fobbing.
We would like to move away from the diaphragm pump to something that will work better
Would anyone be willing to information on their setup for pushing beer to the bowl?
Comment