We have a Thomsen #4 with a Leeson 1hp Washdown motor. 120v single phase. The last two weeks only during whirlpool and transfer through the HX its been winding down then back up to full speed. As if it was a VFD and you were turning it up and down. Never an issue with chemicals or transfers to the brites. We did just have to buy new hoses and went with 1 inch on the inlet hose due to cost savings.
Any ideas?
My thoughts were to
1 New 1.5 inch inlet hose.
2 New 1.5hp motor and keep the 1hp for redundancy.
Chris
Any ideas?
My thoughts were to
1 New 1.5 inch inlet hose.
2 New 1.5hp motor and keep the 1hp for redundancy.
Chris
Comment