Activity Stream

Established in 1979 Ripley Stainless is a strong, family owned purely Canadian company that is here to stay. CHOOSE LOCAL-GO CANADIAN. Ripley...

Established in 1979 Ripley Stainless is a strong, family owned purely Canadian company that is here to stay. CHOOSE LOCAL-GO CANADIAN. Ripley...

Would the k300 handle 20BBL? We will filters our ales and we would like to have it polished and as free of yeast as possible Thx Hi Mattieu,...

Fresh hops are a PITA for most brewers, require special care and lots of planning. Do you know what the shelf life of a fresh picked hop is? It's fun...

That's an awesome business idea if you can get them to grow, but I wouldn't be interested if I was in your area. The only times I've done...

Yes an individual can own both. They can not be on the same premise. But you can serve both at both as long as you sell both to a distributor and...

Its a smaller market but it is out there. I like whole cone directly in the BBT. Also good for late kettle addition, as said above, using a...

Yes i am carbonating with a carbstone without venting. i have been spunding late in fermentation and getting around 5 PSI in the fermentor. ...

Still looking for the right opportunity. Hope to hear from you folks soon!

This is what you want.

BlackH2O - is this something you'd actually be interested in doing for someone? I've got a brewery down in Peru and am looking to get a better...

Any updates on the Winery/Brewery combo? I've got a similar idea in mind for Central Texas

I don't know of any reason not to run a balance line between the head space of the two tanks. You should only need to vent enough CO2 to purge that...

To follow up what R.Cockerell said, you also have to consider that if it is wild yeast/bacteria, it will propagate up in that next batch, and more...

Hey AlexR, thanks for creating the thread, our farm is doing something similar down here in Florida. How has your hops grow been going?

PEX in a conduit is good for outside runs. Just keep direct sunlight off it, and pressure below 175 psi. For safety's sake, all our primary regs are...

You are right, it's all about keeping it cold and having the right carb level. 2.4 to 2.6 is prime range for Goose lines. 1.5 inch hose feeding from...

Yes, Here's a link to maintenance of your heating elements. hope it help :) https://www.wattco.com/2017/09/immersion-heater-maintenance/ Ilan

You are correct that you will need to vent the tank as you are pushing the beer in with CO2. However, being you aren't bubbling CO2 through the beer...

Interesting. Where did you mount it? On top the chute?

I think when you consider that the boil uses all of the available heat from your total element kw to raise the temp to boil, but takes no where near...

Seems if you were using properly diluted chems at high PH and proper temp, rinse, then low PH acid wash for stone under CIP conditions you should...

The bent coils spacing... fascinating. Wonder if it's possible they're doing an aquaman tuning fork type situation.