twist/rinse parts

[timbro81]

Needing to replace the tubular plastic guide rails and the retaining bolts(?) on our 360 degree twist/rinser. I've located the plastic guide rails but can't track down the retaining bolts.
Picture 1 - retaining bolt
Picture 2 - retaining bolt clipped into guide rail
Picture 3 - Entire assembly in frame

http://www.flickr.com/photos/72016256@N08/6499749469/

http://www.flickr.com/photos/72016256@N08/6499749725/

http://www.flickr.com/photos/72016256@N08/6499749967/

Any suggestions or leads would be much appreciated.
Tim Brophy
Marshall Brewing

[Pompeiisneaks]

Tim,

You may want to post the model of your line, so they get an idea... although the twist rinser may not be part of that line, so...

~Phil

[timbro81]

Yeah... there is no model number, name, or anything that I have ever noticed. However I will go over it with a fine tooth comb tomorrow. I'm pretty sure it is a bit of a Frankenstein piece. My luck. Thanks Phil.

[timbro81]

Got it. www.unipak.com. Thanks Tom.

[Pompeiisneaks]

So Tim, did that get it for you?

[timbro81]

Yes, though parts are still being shipped.

[Pompeiisneaks]

ok good, I found that a friend of mine with a 3d printer could maybe manufacture the plastic part and you could put a bolt through it, but if you've got it, you're golden.