Tweet
We are in need of a supplier for gaskets for our fermenter manway doors. They are on the smaller side and all of the companies I have talked to so far don't seem to have anything that will fit.
Here are the specs on the doors:
3 Small Doors: These doors are flat and oval. They are shadowed inside so not much hits the gasket but the overhang is 3/4" so the leg of the gasket would need to come down at least an inch.
Door Circumference = 47 1/2"
Door Width = 15 7/8"
Door Height= 13 1/2"
1 Larger Door: This door is convex and larger than the other 3. The manway is also not shadowed inside. Overhang on it is 3/4" as well.
Door Circumference = 50"
Door Width= 17 1/4"
Door Height= 13 7/8"
The fermenters themselves are made by "Heker" a company out of Mexico but investigation online has turned up zero results for how to get ahold of them. So if anybody has any information on them that would be great to have as well.
Anything that could help solve this problem would be great.
Ben Mills
Fossil Cove Brewing Co. Fayetteville, AR
479-644-4601
fossilcovebrewing@gmail.com
Here are the specs on the doors:
3 Small Doors: These doors are flat and oval. They are shadowed inside so not much hits the gasket but the overhang is 3/4" so the leg of the gasket would need to come down at least an inch.
Door Circumference = 47 1/2"
Door Width = 15 7/8"
Door Height= 13 1/2"
1 Larger Door: This door is convex and larger than the other 3. The manway is also not shadowed inside. Overhang on it is 3/4" as well.
Door Circumference = 50"
Door Width= 17 1/4"
Door Height= 13 7/8"
The fermenters themselves are made by "Heker" a company out of Mexico but investigation online has turned up zero results for how to get ahold of them. So if anybody has any information on them that would be great to have as well.
Anything that could help solve this problem would be great.
Ben Mills
Fossil Cove Brewing Co. Fayetteville, AR
479-644-4601
fossilcovebrewing@gmail.com
Comment