Announcement

Collapse
No announcement yet.

Triclover fitting to City Water

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Triclover fitting to City Water

    A bit of a dumb question as I am building my brewery...

    How do you get city water from an 1.5" copper pipe to a triclover fitting. I thought there would be a simple fitting for this but I cant find one anywhere online. Do you just use a ferrel and solider it onto the pipe?

    -Derrick

  • #2
    Lots of places make adaptors. Not hard to find a 1.5" FNPT to 1.5 triclover adaptor.

    Bradford, JME Ellsworth, or Dixon sanitary should have them.



    I'm assuming, of course, that your 1.5" pipe is threaded at the end? Female or Male NPT adaptors are really easy to find. You can even get hose bib (3/4" NPT) to triclamp fittings. Plumb your whole house in them!

    Nat

    Comment


    • #3
      http://www.mcmaster.com/#tri-clamp-t...ttings/=jkolyo

      McMaster-Carr is always a good place to look. GW Kent has them too.
      Linus Hall
      Yazoo Brewing
      Nashville, TN
      www.yazoobrew.com

      Comment


      • #4
        McMaster is ridiculously priced on these.

        try...



        this is what we used to connect to our water supply and have to complaints thus far
        Beejay
        Pipeworks Brewing Company

        Comment


        • #5
          Thanks guys. That was pretty easy. I saw those but I thought there must be something that goes straight onto copper. This will work out just fine.

          Cheers!

          Comment

          Working...
          X