All,
I am looking for some guidance. I am using a plate filter and am trying to figure out my process. I have been happy with the results so far when serving from the keg, however, we are going to start bottling soon and I am worried about oxygenation. For those out there that filter, I would appreciate your thoughts on my process below:
• Soak the filters in RO water
• Soak all of the plates in StarSan
• Run StarSan through all of the hoses and the pump
• Connect the filter to the fermenter and run enough beer through it to rinse the RO/StarSan water out of the pads
• Filter the rest of the beers into kegs
Other notes, I run the filter at about 2 PSI and I use PALL filters.
Thanks in advance for your feedback.
I am looking for some guidance. I am using a plate filter and am trying to figure out my process. I have been happy with the results so far when serving from the keg, however, we are going to start bottling soon and I am worried about oxygenation. For those out there that filter, I would appreciate your thoughts on my process below:
• Soak the filters in RO water
• Soak all of the plates in StarSan
• Run StarSan through all of the hoses and the pump
• Connect the filter to the fermenter and run enough beer through it to rinse the RO/StarSan water out of the pads
• Filter the rest of the beers into kegs
Other notes, I run the filter at about 2 PSI and I use PALL filters.
Thanks in advance for your feedback.
Comment