So, this may be part of the wiring thread I started below but I'm starting a new thread in case it's not
Ok, pump tecnician came, approved the wiring job for our 1 hp pump and left. It runs wired for 110. Foolishly, we didn't run it connected to the spray ball in the uni tank while he was here. It runs but the ball barely turns. It spouts off about 6-8" on each side. It's weak, not hitting the walls. so back to the drawing board. Any thoughts? Are my 1/2" hose lines to blame? But wouldn't that just create more pressure/spinning?
Ok, pump tecnician came, approved the wiring job for our 1 hp pump and left. It runs wired for 110. Foolishly, we didn't run it connected to the spray ball in the uni tank while he was here. It runs but the ball barely turns. It spouts off about 6-8" on each side. It's weak, not hitting the walls. so back to the drawing board. Any thoughts? Are my 1/2" hose lines to blame? But wouldn't that just create more pressure/spinning?
Comment