PDA

View Full Version : PLC Automation Control Panel from ElTech Electronics (Steam Brewhouse)



RiverSong
10-24-2016, 11:34 AM
Ok this is not a traditional discussion thread. We have a ELTECH Electronic (PLC Automation Control Panel). It controls our Steam Brew house. I was hoping that someone could point me in a direction to getting a new programmer/maintenance company for it. While it likes us for the most part it almost seems to be missing a piece of software.

We are in California however any direction on where to find a new programmer/maintenance person would be so wonderful as I don't really know if something is broken or I just am using the panel incorrectly.

Thank you all very much.

triple
11-02-2016, 11:10 AM
There are a ton of Automation experts out there. Start calling some Control panel shops and find someone familiar with that controller. Also, some good programmers can figure it out from scratch. You should be able to find someone easily.