We are going to be installing our PPM Evolutiuon soon and have some questions about sizing the glycol chiller for the bowl jacket.
...the following is from PPM...
"For the Glycol chilling, it’s ½” NPT female for in and out. The two jackets on the bowl are 5 feet long, 3 inches wide, sitting low where the beer would be at its lowest point (so it’s always in contact with beer until you totally run dry). It’s a pretty small volume, only about 48 cubic inches, plus whatever volume the lines and reservoir would take up."
The chiller will be located very close to the bowl... most likely on a shelf within 5-10 feet of the bowl.
Any recommendations or past experience would be helpful.
...the following is from PPM...
"For the Glycol chilling, it’s ½” NPT female for in and out. The two jackets on the bowl are 5 feet long, 3 inches wide, sitting low where the beer would be at its lowest point (so it’s always in contact with beer until you totally run dry). It’s a pretty small volume, only about 48 cubic inches, plus whatever volume the lines and reservoir would take up."
The chiller will be located very close to the bowl... most likely on a shelf within 5-10 feet of the bowl.
Any recommendations or past experience would be helpful.
Comment