Thanks Timm
Sounds like I have some work to do on this machine. Here I was hoping that since it was brand spankin new I would have a easy go of it for a while. Guess the Italians put a stop to that!
It would be great to get your list of parts you have ordered. THanks!
So I guess you are smart and dont pay attention to the manual about lubricating every 100 or 40 hours like it recommends. I bet I should start tomorrow! Already ran the machine ~ 65 -75 hours and have not lubed everything, only the parts easy to get to. I thought i was getting ahead of the manual too...
Today was fun. I had no less than 5 exploding bottles in the filler and aside from blaming bad bottles I couldnt find any obvious problem with it. Have you had these problems?
About the capper assembly, I have been taking the lower part off after every run and soaking it and letting it dry, but the other part with the springs I will have to look into. I cant think of what you mean. Tomorrow I will look.
Thanks again, Tim. I hope I can be of some use at some point to return the favor the more I get to know this machine.
Sounds like I have some work to do on this machine. Here I was hoping that since it was brand spankin new I would have a easy go of it for a while. Guess the Italians put a stop to that!
It would be great to get your list of parts you have ordered. THanks!
So I guess you are smart and dont pay attention to the manual about lubricating every 100 or 40 hours like it recommends. I bet I should start tomorrow! Already ran the machine ~ 65 -75 hours and have not lubed everything, only the parts easy to get to. I thought i was getting ahead of the manual too...
Today was fun. I had no less than 5 exploding bottles in the filler and aside from blaming bad bottles I couldnt find any obvious problem with it. Have you had these problems?
About the capper assembly, I have been taking the lower part off after every run and soaking it and letting it dry, but the other part with the springs I will have to look into. I cant think of what you mean. Tomorrow I will look.
Thanks again, Tim. I hope I can be of some use at some point to return the favor the more I get to know this machine.
Comment