I'm in the process of wiring our new pump. I want to check with others in the forum re: wiring. It's going on a 20 amp dedicated breaker. I cut off one end of a GFCI extension cord and plan to hard wire that directly to the low voltage wires on the pump.
On the GFCI plug I have:
Black, White and Green (3) wires
On the pump I have 7 wires - pictured and labeled below in the image .
Per the wiring diagram on the pump I've connected Black to P1 (the black wire) and White to T2,T4&T5
Is this correct?
Where Does the green (ground) connect to on the pump?
What do you make of the idea of wiring directly to the GFCI extension? From there I will run a 12 gauge extension to the dedicated 20 Amp outlet. Should I bump that breaker up to a single 30 amp breaker?
The local electrician lives far away here (Costa Rica) and I'm not sure he knows the best way to do this. Thanks.
Comment