Results 1 to 4 of 4

Thread: Taking Package DO reading

  1. #1
    Join Date
    Apr 2016
    Location
    Ireland
    Posts
    1

    Taking Package DO reading

    Hi everyone. I know this was discussed to some extent in older threads but I'm having a very specific issue involving the use of the Hamilton Beverly combined with a Zahm and Nagel piercing device. In a nutshell, we are trialling the equipment and cannot get an "accurate" DO reading from cans or bottles. The PPB measurement is sticking on 0, even if we pass the contents of 3+ cans through the rig. I know this is a good piece of equipment & it is taking accurate readings during calibration.

    Suspect it must be something with our technique:

    >Can is pierced using Zahm and Nagel.

    >Nitrogen gas pressure increased to force beer up inlet tube and into DO meter.

    >Repeated with c. 3 cans

    >No change in DO reading observed.


    The main feeder tube to the DO meter is a significantly wider gauge than the piercing needle, could this be having an effect?

    I've attached a pic of the overall process, let me know if you have any ideas, cheers!

    Name:  IMG_0021 (1).jpg
Views: 332
Size:  90.7 KB

  2. #2
    Join Date
    Dec 2015
    Location
    TBD
    Posts
    1
    Bump. Same issue

  3. #3
    Join Date
    Jan 2016
    Location
    Shoreacres, BC
    Posts
    6
    I have used the Beverly DO meter extensively in a production brewery. They are not really suitable for testing packaged product, in my opinion, because you need to flow so much beer through the meter before the readings stabilize. In the manual it states that you need to flow at least 500 ml/minute for the first minute to purge the oxygen in the meter, then you can turn the flow down and it should take 1-3 minutes to get a stable reading. The temperature must be stable to get a stable DO reading. If you are trying to measure cold beer with a warm meter it takes much more time (and beer) to stabilize in my experience. These meters work well for measuring beer from a tank, but there are other more expensive meters that are more suitable for measuring DO in packaged product, such as the Hach orbisphere.

  4. #4
    Join Date
    Sep 2012
    Location
    Moorhead, Minnesota
    Posts
    601
    We had the same issue with ours. We were told by our rep that we needed to calibrate with higher spec nitrogen. So we went out and got a fill of 5.0 spec nitrogen for $250 and still the same problem. The meter is just inaccurate and shouldn't be considered in the same league as other top tier DO meters. Hamilton's customer service also stinks.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •