Hey all,
I would rather not spend $100 on a a GW Kent Keg Washer Coupler (http://www.gwkent.com/stainless-stee...ling-head.html). I feel like I can make this rather easily myself. I have a good drill and a solid vice. Is it as easy as drilling it out to 1/2"? Is there something that I am missing, can I drill it larger than 1/2"?
I am sure there are at least a few of you that have already done this. Any advice?
I would rather not spend $100 on a a GW Kent Keg Washer Coupler (http://www.gwkent.com/stainless-stee...ling-head.html). I feel like I can make this rather easily myself. I have a good drill and a solid vice. Is it as easy as drilling it out to 1/2"? Is there something that I am missing, can I drill it larger than 1/2"?
I am sure there are at least a few of you that have already done this. Any advice?
Comment