I'm going to be installing an on demand water heater to supply our hot hater for our 3bbl brewhouse. What's the minimum GPM output I should be looking for? I'm assuming somewhere in 6 GPM range would be good.
Announcement
Collapse
No announcement yet.
Hot water GPM for 3bbl??
Collapse
X
-
Originally posted by Rushstop View PostHow were you measuring the amount of water you were using for sparging/ mashing?
However, the amount of strike water does matter. An inline flow meter can be used but they're not 100% accurate, as far as I know. Another way to do it could be to add an insulated storage tank with a sight glass that's large enough for your system. Than fill it with the measured amount of water based off of the calibrated sight glass and mash-in from the tank. The water going into the tank needs to be hot enough though to allow for the heat loss caused by the tank. We're still not sure ho we're going to do it.
Comment
Comment