Anyone know a way to pinpoint a leak from inside a tank. I have a tank that is leaking from the inside. It is double walled brite.
Announcement
Collapse
No announcement yet.
Leaky tank
Collapse
X
-
Leaks
With double-walled fermenters, leaks to the outside can occur at a few spots. Anytime you have a port, this ferrule is penetrating both the inner tank and the outer skin. On the inside, check along the perimeter of the port where the ferrule meets the inner wall. Check for any cracks or pin holes in the weld. These are typically ground flush so look for any hairline marks.
The main area I have seen most leaks originate from is where the legs are welded to the inner tank. These welds are typically long stitches, not a full weld. If there is a small crack or pin holes if the welder wasn't careful, this will allow beer to fill the space between the inner tank and the outer skin. You may see beer leaking from the bottom threads on the leg.
If you have a leak around where the leg meets the inner tank, pressurize the tank and check for CO2 leaks out of the leg by the foot pad.
Cheers,
James
Comment
-
Originally posted by NHBrewer23 View PostWith double-walled fermenters, leaks to the outside can occur at a few spots. Anytime you have a port, this ferrule is penetrating both the inner tank and the outer skin. On the inside, check along the perimeter of the port where the ferrule meets the inner wall. Check for any cracks or pin holes in the weld. These are typically ground flush so look for any hairline marks.
The main area I have seen most leaks originate from is where the legs are welded to the inner tank. These welds are typically long stitches, not a full weld. If there is a small crack or pin holes if the welder wasn't careful, this will allow beer to fill the space between the inner tank and the outer skin. You may see beer leaking from the bottom threads on the leg.
If you have a leak around where the leg meets the inner tank, pressurize the tank and check for CO2 leaks out of the leg by the foot pad.
Cheers,
James
Comment
-
Been there about 4 years ago. I drilled a very small weep hole very close to the lowest point on the dish outside of the tank bottom to let the liquid in the insulation drain and dry out for a few days. In the mean time I sealed between the manway and tank with a stiff epoxy as the joint was not welded. I also sealed any weep holes in the legs, then the one I drilled. I had a welder drill a hole and weld a 1.5" butt weld triclover fitting to the outside of the tank just into the insulation area. I attached a pressure gauge and an air fitting and pressurized the insulation area of the tank, just enough (under 5 psi) to be able to crawl inside the tank and spray every single weld joint with a soapy water solution. It took spraying every joint twice to find the leak, the bubbles were very small. The crack was not visible to the naked eye. Just a spot that had been ground at a weld joint. Welder had it fixed in 10 min. CheersJoel Halbleib
Partner / Zymurgist
Hive and Barrel Meadery
6302 Old La Grange Rd
Crestwood, KY
www.hiveandbarrel.com
Comment
Comment