Hey all, we're contemplating a purchase of an older, 2006 -6 head Meheen. However there is a slight (relative term) difference in the size of longnecks that it was set up for and the size that we are going to use. From what I understand, and correct me if I'm wrong, that the height difference (2.39mm +/-) isn't and issue in terms of adjustment, but rather it's the width that I'm concerned with. Our longneck is 1.09 mm wider than what the machine is set up for. So if the bottles are touching as they pass under the filler heads, the outermost bottles will be spread out 2.725mm than what the machine is currently set for. Is there some type of screw or other adjustment mechanism for the filler heads for slight variability on a machine like this? Also, the manufacturers tolerance on the width of the bottle is (+1.57mm/-1.19mm). So in fact the difference could be a bit less or a bit more. Any comments would be appreciated.
Tom N
Tom N
Comment