We have a long run from the serving tank to taps. Beer pumps are used to push the beer.
Im not very knowledgeable about draft lines and balancing them so am looking for help to fix this.
The beer is becoming very foamy, in most cases, once we get down to about 1-2 bbls (10 bbl serving tank). Recently 2 tanks that have a bit over 5bbls in them are pouring straight foam too which is puzzling me even more. I can see bubbles in the lines going from the serving tank to the flojet beer pumps, the line almost looks to be half foam/half beer.
I carb up each beer with a carb stone, usually good to go within a day. each co2 regulator is set to 15 psi, per instructions from the last brewer. I test levels with a Zahm and Nagel.
Any help would be great.
Im not very knowledgeable about draft lines and balancing them so am looking for help to fix this.
The beer is becoming very foamy, in most cases, once we get down to about 1-2 bbls (10 bbl serving tank). Recently 2 tanks that have a bit over 5bbls in them are pouring straight foam too which is puzzling me even more. I can see bubbles in the lines going from the serving tank to the flojet beer pumps, the line almost looks to be half foam/half beer.
I carb up each beer with a carb stone, usually good to go within a day. each co2 regulator is set to 15 psi, per instructions from the last brewer. I test levels with a Zahm and Nagel.
Any help would be great.
Comment