So planning on hacking up an old keg and turning it into cip vessel. Im thinking at the bottom to add two 1.5 ports for in and out, and then a 2” for a possible heating element later on. For the top im thinking either a 4 or 6 inch port so we can seal it up and pressurize in need be.
Unfortunately im not set up for argon so welds wont be sanitary, but since its just for cip im not too worried.
Anybody else got some experience or advice they wanna share? Different port selection? Extras to add?
Unfortunately im not set up for argon so welds wont be sanitary, but since its just for cip im not too worried.
Anybody else got some experience or advice they wanna share? Different port selection? Extras to add?
Comment