I have seen some posts that relate to this, but not much info.
my new brewpub will be in a newer building (less than 3 years old), that was formerly an attorneys office and has drywall and a splattered and therefore textured drywall cement overspray on all the walls and the corners are rounded over rather than squared.
I have been thinking about putting up FRP panels but the round corners will be a challenge. next I thought about using a spray on USDA approved wall coating system (like the sherwin williams system).
has anyone here used this stuff successfully?
my new brewpub will be in a newer building (less than 3 years old), that was formerly an attorneys office and has drywall and a splattered and therefore textured drywall cement overspray on all the walls and the corners are rounded over rather than squared.
I have been thinking about putting up FRP panels but the round corners will be a challenge. next I thought about using a spray on USDA approved wall coating system (like the sherwin williams system).
has anyone here used this stuff successfully?