So as a small nano, we have to force carbonate directly in the keg after racking. But with a Sanke coupler, there's no easy way to close off the beer-out port while still allowing CO2 to flow in through the gas-in port.
We could hook the kegs up to our taps, but that would lock-out that tap from being used until the beer was fully carbed. We could use barbed 3/16" hose plugs (http://www.beveragefactory.com/draft...s/S19-4.shtml), but then I have to put together an assembly of nut + gasket + tailpiece + short section of hose + hose plug.
What I really want is a 7/8"-14 stainless steel threaded cap. Or a blank tailpiece with no barbed protrusion.
Does anyone know a source for either of these? What do others do in this case?
Thanks!
We could hook the kegs up to our taps, but that would lock-out that tap from being used until the beer was fully carbed. We could use barbed 3/16" hose plugs (http://www.beveragefactory.com/draft...s/S19-4.shtml), but then I have to put together an assembly of nut + gasket + tailpiece + short section of hose + hose plug.
What I really want is a 7/8"-14 stainless steel threaded cap. Or a blank tailpiece with no barbed protrusion.
Does anyone know a source for either of these? What do others do in this case?
Thanks!
Comment