I have a chiller system that has been sitting around. I never needed it before, but we are getting ready to bottle and need to bring down the temperature of the beer. Right now all tanks are in a cold room. Single wall tanks that we fitted with a cooling loop inside of tanks.
I have a 5 ton compressor with a basic counter flow heat exchanger.
A 125 gal. reservoir tank and 2 pumps.
Glycol leaves tank goes to pump then through a solenoid valve and then to heat exchanger, and back to tank.
Refrigerant leaves compressor goes through solenoid valve then expansion valve and through heat exchanger and back to comprssor.
My question is does the t-stat control both solenoid valves and the pump?
On my loop to my four 7bbl. tanks do I need some sort of pressure relief valve? And if so what do you recomend?
This will be a great starting point for me.
Thanks in advance,
Adrian
I have a 5 ton compressor with a basic counter flow heat exchanger.
A 125 gal. reservoir tank and 2 pumps.
Glycol leaves tank goes to pump then through a solenoid valve and then to heat exchanger, and back to tank.
Refrigerant leaves compressor goes through solenoid valve then expansion valve and through heat exchanger and back to comprssor.
My question is does the t-stat control both solenoid valves and the pump?
On my loop to my four 7bbl. tanks do I need some sort of pressure relief valve? And if so what do you recomend?
This will be a great starting point for me.
Thanks in advance,
Adrian
Comment