I have a used Baldor High Efficiency Electric Motor Pump-3 Phase/1.5HP (M3550). It has a tri-clamp fitting and it is one of my two pumps on my Specific Mechanics brew system. This pump is leaking, and it seems to be leaking around the shaft area, not around the area of the large tri-clamp fitting. I am not the most knowledgable about pumps either. It seems like things just need to be tightened up, as my leak has gotten a little worse over the last week or two.
I have taken it apart and the seals seem OK, but I will be purchasing two replacement kits. Is there a good place to purchase seal kits other than straight through Baldor?
Any Thoughts? Thanks in advance for any help.
Jon Christiansen
Head Brewer, Lucette Brewing Co.
Menomonie, WI
I have taken it apart and the seals seem OK, but I will be purchasing two replacement kits. Is there a good place to purchase seal kits other than straight through Baldor?
Any Thoughts? Thanks in advance for any help.
Jon Christiansen
Head Brewer, Lucette Brewing Co.
Menomonie, WI
Comment