Hey all,
been having a bit of diastaticus poppin' up recently. busy investigating now with a lab to figure out where it is and isn't present in our process. Too early to tell, but I suspect the meheen might be the culprit. and even if it isn't, good deep cleans are always welcome.
Since you are not supposed to clean warmer than 30*C I was wondering if anyone has experience or advice on giving this bad boy a mega clean.
I've done a PBW cycle, followed by enzybrew. Enzybrew works optimally around 45 degrees I believe, so I did a slightly higher concentration and a 3 hours soak starting at around 28*C and regularly replenishing with a fresh solution.
silicone hoses were also quite recently replaced.
any blind spots to consider?
Cheers!
-e
been having a bit of diastaticus poppin' up recently. busy investigating now with a lab to figure out where it is and isn't present in our process. Too early to tell, but I suspect the meheen might be the culprit. and even if it isn't, good deep cleans are always welcome.
Since you are not supposed to clean warmer than 30*C I was wondering if anyone has experience or advice on giving this bad boy a mega clean.
I've done a PBW cycle, followed by enzybrew. Enzybrew works optimally around 45 degrees I believe, so I did a slightly higher concentration and a 3 hours soak starting at around 28*C and regularly replenishing with a fresh solution.
silicone hoses were also quite recently replaced.
any blind spots to consider?
Cheers!
-e
Comment