Howdy all,
When all you plate-and-framers out there load your pads into the filter rack, do you "reverse" the position of the two pads before and after the divider plate? That is to say is the "smooth side" against the sludge side and the "rough side" against the fitrate side of JUST the two pads against the divider plate. I was advised by an industry professional to set it up this way but it just doesn't make sense to me.
Dave
When all you plate-and-framers out there load your pads into the filter rack, do you "reverse" the position of the two pads before and after the divider plate? That is to say is the "smooth side" against the sludge side and the "rough side" against the fitrate side of JUST the two pads against the divider plate. I was advised by an industry professional to set it up this way but it just doesn't make sense to me.
Dave
Comment