I have a customer who just bought a used 15 bbl kettle with an inch of material burned onto the bottom. He is new in the business and is wilting at the prospect of what it will take to restore the kettle. Does anyone know of anything he can use to loosen or soften the burned stuff so it isn't so hard to chip off?
Announcement
Collapse
No announcement yet.
Any ideas on how best to remove burned-on material from kettle bottom?
Collapse
X
-
1" of burned crud? ouch!
Well, I haven't had to deal with that much burned on the bottom of a kettle, but in the past I have soaked it in hot cautic or Bar Keeper's Friend (http://www.barkeepersfriend.com/index2.htm), which you can find in the cleaning isle at most hardware stores. And then you scrub the hell out of it with steel wool.
If you want to remove the heat discoloration, I would recommend a cleaning product called Flitz Metal Polish Paste (http://www.flitz.com/) which you can sometimes find at the hardware store.
That sounds like a helluva mess, so good luck.
Comment
-
Do NOT use steel wool unless you are 100% absolutely sure that it is stainless steel wool. Any carbon steel contact will rust the area of contamination. I suggest a new stainless wire wheel with tight knots and an angle grinder if there is some remaining discoloration. Don't use a stainless wire wheel that has been used on carbon steel.Phillip Kelm--Palau Brewing Company Manager--
Comment
-
Originally posted by Todd HicksFind the former brewer and stick his lazy butt in the kettle with your assortment of cleaning apparatus and chemicals. Keep locked in kettle until the kettle is perfectly clean and individual has learned the first lesson of brewing beer; cleaning and polishing kettles!Jeff Byrne
Comment
-
Yes. Carbon steel will smear into the stainless substrate and cause it to rust. Passivation may eliminate some of the carbon, but depending on how much/how deep the contamination is, you'll certainly have rust in the future. Most stainless shops do not have any carbon steel in them. If a manufacturer does both stainless and carbon steel, they are almost always fabricated in separate shops. Of course there are stainless scrubbies for restaurant service that are in many breweries, but don't buy hardware-store steel wool! I would also advise against using any muriatic (=hydrochloric) acid for passivation. Chlorine at high temperatures will attack welds and high stress points in stainless. Use nitric acid CIP at 15% for 15 minutes at about 110 degrees F. Be sure to remove any brass parts, ventillate properly, wear protection, and AIR DRY the tank! Rinsing after the acid wash will not allow proper passivation. Cheers and good luck!Phillip Kelm--Palau Brewing Company Manager--
Comment
-
Hi,
In one recent project we had a hot liquor tank full of build-up, rusty type deposits, etc. I got in a contractor with a high pressure blaster (wasn't an absolutley full-on one, just one that came mounted on the back of a small truck) - came up nice and shiny. That would be my ideal preference as (I don't think!) the high pressure water will affect the passive layer of the stainless, and you won't have any manual scrubbing. Then you might be able to just run a normal CIP and caustic brew to finish it off.......
For the CIP you may want to use chlorinated caustic as it is better for removing proteinaceous deposits. Then for good measure you could always give a quick circulation with nitric acid (to repassivate).
Alex
Comment
Comment